inserindo o canudo do cilindro de gás na glande para uma bora ereçao.
14,632 80%
,jpeg/023/823/227/1280x720.c.jpg.v1695833005)
Com o cilindro de gás oxigênio implantei o canudo na glade e depois foram muitas gozadas extremas.
há 9 meses
,jpeg/021/214/204/1280x720.4.jpg)
,jpeg/024/637/749/v2/320x180.245.jpg)
,jpeg/002/701/148/1280x720.2.jpg)
,jpeg/024/841/975/1280x720.17196299.jpg)
,jpeg/016/101/243/1280x720.1.jpg)
,jpeg/023/838/049/v2/320x180.210.jpg)
,jpeg/023/820/646/1280x720.c.jpg.v1695779127)
,jpeg/024/824/186/1280x720.17192906.jpg)
,jpeg/010/262/219/1280x720.10.jpg)
,jpeg/013/390/644/1280x720.10.jpg)
,jpeg/024/006/955/1280x720.c.jpg.v1700139343)
Comentários
4
Por favor, inicie sessão ou registe-se para publicar comentários
DRECK
Hallo was hast du da für Gas genommen ? Lg Richard
Langweilig. Was soll das
Yayyy!!! You tried! Thank you. Melt the end with a lighter slightly to round off the sharp edge of that plastic. Also, you may want to cut the last 1/4" off the end first because I think the second graduation up will fit you just fine, perfectly in fact. That first stem is too long for now. Just be sure to melt the edges slightly with a lighter, rounding the edges off while it's still maliable with your fingers. Let it cool then send it in a little slowly going about half an inch. Tape it there if you need, which will free that hand to use elsewhere. Good job bro. Hot to finally see this . I knew you could do it. HOTAF